As mentioned in an earlier blog posting, the single primer coat of Ronseal Quick Drying Woodstain was left to dry for at least a week. It was very glossy. It was followed up with a single coat of matt black acrylic car paint from an aerosol can, and left to dry for a further week. (This was sprayed outside in a well-ventilated garage: not a good thing to do inside a house.) Despite being matt black, this also turned out glossy! This was the base coat, forming the shadows. So far, so good, none of the paint had shown signs of cracking or flaking off.
The next stage would be a more challenging test. Using a 1/4 inch flat Pro Arte Acrylix brush, Warm Grey from the Daler Rowney System 3 artists' acrylic paint range was dry-brushed from the head downwards over the entire figure. This formed the mid-tones. The following day, grey was replaced by Titanium White from the same range, and dry-brushing was repeated more lightly to produce the highlights. The figure should now be reminiscent of a black and white photograph.
As noted above, the glossy black shadow finish made adding the grey and white layers more difficult with less of a key to work with, but remarkably the black undercoat remained intact! So the use of quick-drying woodstain as a primer on this polythene-like plastic seems to have been a success (so far).One downside of the dry-brushing technique is that it shows up any blemishes in the figure -- mould lines, flash, and moulding defects.
No comments:
Post a Comment